Highland Cow with American Flag (Saddle Tan) Engraved Leatherette Hat Patch - MR01

Explore our Highland Cow patch featuring an American flag design. This unique hat patch is perfect for animal lovers and adds a whimsical touch to any hat.

Engraved on Lonestar Adhesive's Premium Rawhide Leatherette with Durabull Adhesive.  Stock your hat bar with all of our premade patches!  Search "MR01" on this site to find everything that we (Ink and Ember) offer for a flat $5 shipping (the more patches you buy, the more profitable your hat bar is!)

These patches are engraved on leather to give a clean and unique image on the leatherette which is then laser cut precisely around the image and are great for hats, backpacks and anything you can imagine.   Hat not included.

Patches are sized to standard sizes for hats (approximately 2" - 2.5" tall or wide) - if you need specific sizing on a patch, pleaes message us before purchasing.

Leatherette is a vegan leather with heat activated adhesive already on the back.

APPLICATION INSTRUCTIONS : 

1. Preheat hat in hat press for 30 seconds at 325°F with thin silicone sheet between the hat and platen
2. While heating hat, heat the back of the patch with a heat gun on low for 15 to 30 seconds until you see the adhesive change and the patch may begin to curl (reflective, more tacky) (note: it's a heat gun not a blow drier). This shows that the print has become more pliable and ready to attach to the hat.
3. When 30 seconds is over remove the hat press heater and silicone pad from the hat and apply the patch to the hat in desired location, careful it's hot. 
4. Press again for 30 seconds with light to medium pressure with a silicone pad on top of the patch and hat. Check edges of the patch and make sure it stuck, if not adhered on the edges, repress the hat until you get desired results.